Surface Treatment of Polylactic Acid Fiber by Starch Nanocrystals and Interface Modification of Polylactic Acid Fiber-Reinforced Starch Composites

Authors

  • Xiaodong Zhou State Key Laboratory of Chemical Engineering, East China University of Science and Technology, Shanghai 200237, China
  • Ming Sun State Key Laboratory of Chemical Engineering, East China University of Science and Technology, Shanghai 200237, China
  • Huihuang Ma State Key Laboratory of Chemical Engineering, East China University of Science and Technology, Shanghai 200237, China
  • Shaoxia Yang State Key Laboratory of Chemical Engineering, East China University of Science and Technology, Shanghai 200237, China
  • Yingxuan Chen State Key Laboratory of Chemical Engineering, East China University of Science and Technology, Shanghai 200237, China
  • Haiyan Liu State Key Laboratory of Chemical Engineering, East China University of Science and Technology, Shanghai 200237, China

DOI:

https://doi.org/10.12974/2311-8717.2022.10.02

Keywords:

Polylactic acid fiber, Starch nanocrystals, Surface treatment, Interface, Strength

Abstract

The surface of polylactic acid fiber (PLAF) was treated with self - manufactured starch nanocrystals (SNCs) to improve its interfacial adhesion with the starch matrix. Determination of optimum dispersion conditions of SNCs dispersion by transmittance. The effects of direct oscillatory deposition, chemical grafting SNCs modification, and SNCs dispersion concentration on the surface treatment effect of PLAF and its interfacial bonding with starch matrix were investigated. The results showed that the SNCs were successfully introduced into the PLAF surface, moreover, the modifying effect of the chemical grafted SNCs was better than the direct oscillatory deposition, the distribution of SNCs particles was more uniform on the fiber surface, strong chemical bonding to the fiber surface, make up for the surface damage of the fibers caused by aminolysis. At the SNCs dispersion concentration of 10 g/L, the PLAF tensile strength could be maintained at 582 MPa, a large amount of starch was evenly attached to the surface after pulling out. It showed that a strong interface bond with the starch matrix, the highest IFSS value was 2.57 MPa and the increase was by about 63 %. Therefore, the introduction of SNCs for interfacial modification of PLAF is of great significance and deserves further exploration.

References

Yu X, Chen L, Jin Z, Jiao A (2021) Research progress of starch-based biodegradable materials: a review. J Mater Sci 56: 11187-11208. https://doi.org/10.1007/s10853-021-06063-1

Siqueira L, Arias C, Maniglia BC (2020) Starch-based biodegradable plastics: methods of production, challenges, and future perspectives. Curr Opin Food Sci 38: 122-130. https://doi.org/10.1016/j.cofs.2020.10.020

Heidarian P, Behzad T, Sadeghi M (2017) Investigation of cross-linked PVA/starch biocompos ites reinforced by cellulose nanofibrils isolated from aspen wood sawdust. Cellulose 24: 3323-3339. https://doi.org/10.1007/s10570-017-1336-4

Zhang YC, Rempel C, Liu Q (2014) Thermoplastic starch processing and characteristics-a review. Food Sci Nutr 54: 1353-1370. https://doi.org/1080/10408398.2011.636156

Ashogbon AO, Akintayo ET (2014) Recent trend in the physical and chemical modification of starches from different botanical sources: a review. Starch-Starke 66: 41-57. https://doi.org/10.1002/star.201300106

Gao J, Luo ZG, Luo FX (2012) Ionic liquids as solvents for dissolution of corn starch and homogeneous synthesis of fatty-acid starch esters without catalysts. Carbohydr Polym 89: 1215-1221. https://doi.org/10.1016/j.carbpol.2012.03.096

Savadekar NR, Mhaske ST (2012) Synthesis of nano cellulose fibers and effect on thermoplastics starch based films. Carbohydr Polym 89: 146-151. https://doi.org/10.1016/j.carbpol.2012.02.063

Chang Y, Sun T, Fan C, Zhou X (2018) The effect of surface modification on the properties of sisal fiber and improvement of interfacial adhesion in sisal/starch composites induced by starch nanocrystals. Compos Interfaces 25: 1-14. https://doi.org/10.1080/09276440.2018.1450586

Jiang L, Liu B, Zhang JW (2009) Novel high-strength thermoplastic starch reinforced by in situ poly(lactic acid) fibrillation. Macromol Mater Eng 294: 301-305. https://doi.org/10.1002/mame.200900018

Weng F, Wang M, Ernest K, Ma N, Wu Z, Wu Q (2018) Effects of pba-based polyurethane prepolymer as compatibilizer on the properties of polylactic acid-starch composites. Starch-Starke 71: 3-4. https://doi.org/10.1002/star.201800205

Sreekumar PA, Thomas SP, Saiter JM, Joseph K, Unnikrishnan G, Thomas S (2009) Effect of fiber surface modification on the mechanical and water absorption characteristics of sisal/polyester composites fabricated by resin transfer molding. Compos Pt A-Appl Sci Manuf 40: 1777-1784. https://doi.org/10.1016/j.compositesa.2009.08.013

Angellier H, Choisnard L, Molina-Boisseau S (2009) Optimization of the Preparation of Aqueous Suspensions of Waxy Maize Starch Nanocrystals Using a Response Surface Methodology. Biomacromolecules 5: 1545-1551. https://doi.org/10.1049/el:20071208

Chen Y, Zhou X, Yin X, Lin Q, Zhu M (2013). A novel route to modify the interface of glass fiber-reinforced epoxy resin composite via bacterial cellulose. Int J Polym Mater Polym Biomat 63: 221-227. https://doi.org/10.1080/00914037.2013.830250

Liu C, Li K, Li X, Zhang M, Li J (2021). Formation and structural evolution of starch nanocrystals from waxy maize starch and waxy potato starch. Int J Biol Macromol 180: 625632. https://doi.org/10.1016/j.ijbiomac.2021.03.115

Chang Y, Sun TS, Fan C, Zhou, XD (2018) The effect of surface modification on the properties of sisal fiber and improvement of interfacial adhesion in sisal/starch composites induced by starch nanocrystals. Compos Interfaces 25: 1-14. https://doi.org/10.1080/09276440.2018.1450586

Arbelaiz A, Cantero G, B. Fernández, Mondragon I, Kenny JM (2010) Flax fiber surface modifications: effects on fiber physico mechanical and flax/polypropylene interface properties. Polymer Composites, 26: 324-332. https://doi.org/10.1002/pc.20097

Li C, Sun PD, Yang C (2018) Emulsion stabilized by starch nanocrystals. Starch-Starke, 64: 497-502. https://doi.org/10.1002/star.201100178

ihem, Bel, Haaj, Albert, Magnin, Christian, Pétrier, Sami, Boufi (2013) Tarch nanoparticles formation via high power ultrasonication. Carbohydr Polym 92: 1625-1632. https://doi.org/10.1016/j.carbpol.2012.11.022

Wu G, Ma L, Li L, Wang Y, Fei X, Zhong Z (2016) Interface enhancement of carbon fiber reinforced methy lphenylsilicone resin composites modified with silanized carbon nanotubes. Mater Des 89: 1343-1349. https://doi.org/10.1016/j.matdes.2015.10.016

Flavio de Andrade Silva, Nikhilesh Chawla, Romildo Dias de Toledo Filho (2009) Tensile behavior of high performance natural (sisal) fibers. Compos Sci Technol 68: 3438-3443. https://doi.org/10.1016/j.compscitech.2008.10.001

Chen Y, Liu C, Chang PR, Cao X, Anderson DP (2009) Bionanocomposites based on pea starch and cellulose nanowhiskers hydrolyzed from pea hull fibre: effect of hydrolysis time. Carbohydr Polym 76: 607-615. https://doi.org/10.1016/j.carbpol.2008.11.030

Downloads

Published

2022-11-23

How to Cite

Zhou, X. ., Sun, M. ., Ma, H. ., Yang, S. ., Chen, Y. ., & Liu, H. . (2022). Surface Treatment of Polylactic Acid Fiber by Starch Nanocrystals and Interface Modification of Polylactic Acid Fiber-Reinforced Starch Composites. Journal of Composites and Biodegradable Polymers, 10, 6–18. https://doi.org/10.12974/2311-8717.2022.10.02

Issue

Section

Articles